Instructional VideoDescription: View the instructional video on setting
up and using the TRUTH Camera Arm.
  • Thread the ratchet strap through the slot on the leveling base (See Picture 1 below).
  • Press the leveling base against the tree and wrap the strap around the tree (See Picture 2 below).
  • Now, thread it through the ratchet (See Picture 3 below). Tighten the ratchet strap until the leveling base is snug against the tree. We recommend that you place the leveling base about waist high to no higher than 4 inches above your waist when sitting in your stand. Once the leveling base is positioned where you want it, tighten the ratchet strap which secures the leveling base against the tree.
  • Once you have the leveling base secured where you want it, insert the camera arm post into the leveling base (See Picture 4 below).
  • Use the leveling bubble that is located on the fluid motion camera head to check the level of the camera arm in all directions (See Picture 5 below).
  • Make any adjustments needed by using the adjusting knob on the leveling base. Loosen the adjusting knob, make your adjustments and retighten the adjustment knob (See Picture 6 below).
  • Attach the quick release plate to the bottom of your camera (See Picture 7 below).
  • Place your camera with the quick release plate into the quick release cavity on the fluid motion camera head (See Picture 8 below).
  • Tighten or loosen the tilting and panning hinges to your desired tension (See Picture 9 below).